F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Steering Gear: Service and Repair
Replacement
Gear Housing Replace
Fig. 5 Steering Gear Housing
1. Remove snap ring from lower end of housing.
2. Remove dust seal using impact hammer tools Nos. T58L-101-A and T59L-100-B, or equivalents.
3. Remove and discard pressure seal in same manner as dust seal.
4. Apply suitable lubricant to new pressure and dust seal.
5. Position dust seal on seal replacer tool No. T77L-3576-A, or equivalent, so raised lip of seal faces tool.
6. Position pressure seal on tool with seal lip away from tool and flat side of seal contacting flat side of dust seal.
7. Insert seal driver tool into sector shaft bore and drive tool in until seals clear snap ring groove. To ensure proper sealing, seals must not be
bottomed against bearing.
8. Install snap ring in groove in housing.
Piston & Ball Nut
Fig. 2 Ball And Nut Housing
1. Remove Teflon(R) ring and O-ring from piston and ball nut.
2. Dip a new O-ring in gear lube and install on piston and ball nut.
3. Install new Teflon(R) ring on piston and ball nut, being careful not to stretch it any more than necessary.
Valve Housing
