F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Intermediate Servo Assembly
7. Remove seals from piston and cover.
NOTE: Replace complete piston and rod assembly if piston or piston sealing lips are damaged.
INSTALLATION
1. Lubricate new seals with transmission fluid, then install in cover and piston.
2. Lubricate piston with transmission fluid and install in cover.
3. Position new gasket on servo cover and spring on piston rod.
4. Insert piston and cover in case. Secure cover with bolts, carefully backing off band adjusting screw while torquing cover bolts to 14-20 ft lbs.
Ensure vent tube retaining clip is in place.
5. Connect muffler inlet pipe to exhaust manifolds.
6. Raise transmission high enough to install engine rear support. Secure support to extension housing. Lower transmission as required to install
support to crossmember bolt.
7. Remove jack and adjust band.
8. Lower vehicle, then add fluid as necessary.