F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
1.
Inspect the # 3 and # 4 seal ring area and the rear bushing on the Stator Support (Figure 1).
2.
Replace the Stator Support with a new Stator Support (F4AZ-7A108-A) which has a rear U-groove bushing.
NOTE:
THIS STATOR SUPPORT MUST BE USED WITH # 3 AND # 4 ID/OD CHAMFERED CAST IRON SEAL RINGS (F4AZ-7D019-A).
3.
Inspect the mating area of the Forward Clutch Cylinder and Input Shaft Assembly (Figure 2).
4.
Replace the assembly if the area is grooved or shows an indication of excessive wear.