F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Manual Lever Seal Removal
10. Remove manual lever seal using seal remover tool No T74P-77248-A and slide hammer tool No. T5OT-1OO-A or equivalent.
INSTALLATION
1. Reverse procedure to install, noting the following:
a. Install seal using shift lever seal replacer tool No. T74P-77498-A or equivalent.
b. Install new outer manual lever nut and torque to 20-29 ft lbs.
c. Inner detent lever must be sealed on flats of shaft, and rod assembly must be through guide plate.
d. Inner lever pin must be aligned with manual lever.
e. Align manual lever position sensor for Neutral gear position using gear position sensor adjuster No. T89T-70010-J or equivalent.
