F 250 2WD Pickup V8-7.3L DSL Turbo VIN F (1994)
Wheel Bearing: Service and Repair
Front
REMOVAL AND INSTALLATION
1. Raise and support front of vehicle and remove front wheels.
2. Remove brake caliper and position aside, leaving brake lines attached.
CAUTION: Do not allow weight of caliper to hang on brake lines.
3. Remove grease cap, cotter pin, locknut, adjusting nut and washer, then the outer bearing cone and roller.
4. Remove hub and rotor and discard grease retainer.
5. Remove inner bearing and roller.
6. Reverse procedure to install.
