F 250 2WD Super Duty V10-6.8L (2009)
4. Release the 3/4 button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.
Remote Memory Activation
Remote Memory Activation
1. Position the driver seat, adjustable pedals and mirrors to the desired position.
2. Press and hold either memory button (1 or 2) for 5 seconds. A tone will be heard after 1-1/2 seconds when the memory store is done. Continue to
hold until a second tone is heard after 5 seconds.
3. Within 3 seconds, press the LOCK button on the Remote Keyless Entry (RKE) transmitter.
4. If a second memory setting is desired, repeat the procedure with the second RKE transmitter.
Remote Memory Deactivation
Remote Memory Deactivation
1. Press and hold either memory button (1 or 2) for 5 seconds. A tone will be heard after 1-1/2 seconds when the memory store is done. Continue to
hold until a second tone is heard after 5 seconds.
2. Within 3 seconds, press the UNLOCK button on the Remote Keyless Entry (RKE) transmitter.
3. If a second memory setting is desired to be deactivated, repeat the procedure with the second RKE transmitter.
Perimeter Lighting Feature Programming
Perimeter Lighting Feature Programming
Programming the Perimeter Lighting Feature Using the Door Lock Control Switch
NOTE: The following steps must be carried out within 30 seconds or the procedure will need to be repeated. If the procedure needs to be repeated, wait
30 seconds between programming sessions.
1. Turn the ignition switch from the OFF to the ON position.
2. Press the unlock button on the door lock control switch 3 times.
3. Turn the ignition switch from the ON to the OFF position.
4. Press the unlock button on the door lock control switch 3 times.
5. Turn the ignition switch to the ON position. The horn chirps one time to indicate that programming mode is entered.
6. NOTE: The unlock button must be pressed twice within 5 seconds.
Within 30 seconds of entering the programming mode, press the unlock button on the door lock control switch twice to enable/disable the
perimeter lighting feature. The horn chirps once if the perimeter lighting is disabled or a chirp followed by a honk if the perimeter lighting is
enabled.
7. Programming ends when the ignition switch state changes or times out after 2 minutes.
Stepped Unlock Programming
Stepped Unlock Programming
1. With the ignition switch in the OFF position, press the LOCK and UNLOCK buttons on the Remote Keyless Entry (RKE) transmitter
simultaneously for 4 seconds.
-
The turn signals flash twice to indicate the mode change.
2. Repeat Step 1 to enable/disable the stepped unlocking feature.
