F 250 2WD Super Duty V10-6.8L (2009)
Brake Pedal Assy: Service and Repair
Brake Pedal and Bracket
NOTE: Adjustable pedal shown, fixed pedal similar.
Removal and Installation
Vehicles equipped with adjustable pedals
1. Disconnect the adjustable brake pedal drive cable.
All vehicles
2. Remove the brake pedal cotter pin cover and pin.
3. Slide the stoplamp switch and booster push rod from the brake pedal pin.
4. Remove the 2 brake pedal bracket-to-column brace nuts.
-
To install, tighten to 25 Nm (18 lb-ft).
5. Remove the 4 brake booster-to-pedal bracket nuts.
-
To install, tighten to 25 Nm (18 lb-ft).
6. Position the brake booster assembly forward enough to allow the brake pedal bracket to clear the booster studs.
