F 250 2WD Super Duty V10-6.8L (2009)
Timing Chain: Diagrams
NOTICE: Timing chain procedures must be followed exactly or damage to valves and pistons will result.
NOTE: There are 61 links in each timing chain.
If copper links are not visible, mark 2 links on one end and 1 link on the other end, and use as timing marks.
Position the crankshaft with the Crankshaft Holding Tool, then remove the tool.
Position the camshafts.
- Rotate the LH camshaft until the timing mark is at approximately 12 o'clock.
- Rotate the RH camshaft until the timing mark is at approximately 11 o'clock.
Install the crankshaft sprocket, making sure the flange faces forward.
Install the lower end of the LH timing chain, aligning the timing marks.
