F 250 2WD Super Duty V10-6.8L (2009)
NOTE: Camshaft shown installed to clarify camshaft roller follower position.
NOTE: Lubricate the camshaft roller followers prior to installation.
Install only the identified camshaft roller followers onto the LH cylinder head.
3. Install the LH and RH camshafts.
-
Lubricate the camshaft and camshaft journals with clean engine oil prior to installation.
4. Install the LH and RH camshaft bearing caps in their original locations.
-
Lubricate the camshaft bearing caps with clean engine oil.
-
Position the front camshaft bearing cap.
-
Position the remaining camshaft bearing caps.
-
Install the 24 bolts loosely.
5. Tighten the 12 LH camshaft bearing cap bolts in 2 stages:
-
Stage 1: Tighten to 8 Nm (71 lb-in) in the sequence shown.
-
Stage 2: Tighten an additional 45 degrees.
Camshaft - LH
6. Tighten the 12 RH camshaft bearing cap bolts in 2 stages:
-
Stage 1: Tighten to 8 Nm (71 lb-in) in the sequence shown.
-
Stage 2: Tighten an additional 45 degrees.
