F 250 2WD Super Duty V10-6.8L (2009)
If the vehicle is not equipped with a TBC module, INSTALL the removed fuse. GO to S8.
INSTALL the removed fuse. GO to S7.
-------------------------------------------------
S7 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE TBC MODULE DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: Smart Junction Box (SJB) Fuse 33 (10A) and BJB Fuse 5 (30A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test D. See: Pinpoint Test D: The Trailer Brake Control Module (TBC) Module Does Not Respond To
The Scan Tool
No
INSTALL the removed fuses. GO to S8.
-------------------------------------------------
S8 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE RCM DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 32 (10A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test E. See: Pinpoint Test E: The Restraints Control Module (RCM) Does Not Respond To The Scan
Tool
No
If the vehicle is equipped with an APIM, INSTALL the removed fuse. GO to S9.
If the vehicle is not equipped with an APIM, INSTALL the removed fuse. GO to S10.
-------------------------------------------------
S9 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE APIM DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 40 (20A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. Go To Pinpoint Test Q. See: Pinpoint Test Q: The Accessory Protocol Interface Module (APIM) Does Not Respond To
The Scan Tool
No
INSTALL the removed fuse. GO to S10.
