F 250 2WD Super Duty V10-6.8L (2009)
-------------------------------------------------
S10 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE IC DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: SJB Fuse 26 (10A) and 36 (5A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test C. See: Pinpoint Test C: The Instrument Cluster (IC) Does Not Respond To The Scan Tool
No
If the vehicle is equipped with a diesel engine, INSTALL the removed fuses. GO to S11.
If the vehicle is not equipped with a diesel engine, INSTALL the removed fuses. An intermittent fault is not present. Go To Pinpoint Test T. See:
Pinpoint Test T: No High Speed Controller Area Network (HS-CAN) Communication, All Modules Are Not Responding
-------------------------------------------------
S11 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE EVRT ACTUATOR DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: BJB Fuse 74 (20A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuse. REFER to Computers and Control Systems Information, Pinpoint Tests, pinpoint test AK to diagnose no communication
with the EVRT actuator.
No
If the vehicle is equipped with a TCM, INSTALL the removed fuse. GO to S12.
If the vehicle is not equipped with a TCM, INSTALL the removed fuse. GO to S13.
-------------------------------------------------
S12 CHECK FOR RESTORED NETWORK COMMUNICATION WITH THE TCM DISABLED
NOTE: When re-running the network test, the network test application must be first closed or the screen display will revert back to the prior run network
test results.
-
Disconnect: BJB Fuses 37 (10A) and 72 (15A).
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
Repeat the network test.
-
Do all other modules pass the network test?
Yes
INSTALL the removed fuses. Go To Pinpoint Test G. See: Pinpoint Test G: The Transmission Control Module (TCM) Does Not Respond To The Scan
Tool
No
INSTALL the removed fuses. GO to S13.
-------------------------------------------------
