F 250 2WD Super Duty V10-6.8L (2009)
-
Are the resistances greater than 1,000 ohms?
Yes
CONNECT the negative battery cable. GO to V4.
No
GO to V21.
-------------------------------------------------
V4 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO VOLTAGE
-
Ignition ON.
-
Measure the voltage between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit VDB07
(VT/OG), harness side and ground.
-
Is the voltage greater than 6 volts?
Yes
REPAIR the circuit. CLEAR the DTCs. REPEAT the network test with the scan tool.
No
The Controller Area Network (CAN) has tested within specifications. Go To Pinpoint Test U to diagnose the intermittent MS-CAN fault. See: Pinpoint
Test U: Intermittent No Medium Speed Controller Area Network (MS-CAN) Communication, One Or More Modules Are Not Respo
-------------------------------------------------
V5 CHECK THE MS-CAN TERMINATION RESISTOR
-
Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and the DLC C251-11, circuit VDB07 (VT/OG), harness
side.
-
Is the resistance between 108 and 132 ohms?
Yes
GO to V6.
No
GO to V9.
-------------------------------------------------
V6 CHECK THE MS-CAN TERMINATION RESISTOR WITH THE SJB DISCONNECTED
-
Disconnect: SJB C2280b.
