ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3177 > < Initial Inspection and Diagnostic Overview|Page 3175
Page 79
background image

If the vehicle is not equipped with a SDARS module, GO to V23.

-------------------------------------------------
V22 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE SDARS MODULE
DISCONNECTED

-

Disconnect: SDARS Module C2400.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 5,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to V32.

No

GO to V23.

-------------------------------------------------
V23 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE HVAC MODULE
DISCONNECTED

-

Disconnect: HVAC Module C228a (EATC) or C2357a (EMTC).

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

-

Are the resistances greater than 5,000 ohms?

Yes

CONNECT all modules. CONNECT the negative battery cable. GO to V33.

No

If the vehicle is equipped with a DSM, GO to V24.

If the vehicle is not equipped with a DSM, GO to V25.

-------------------------------------------------
V24 CHECK THE MS-CAN (+) AND MS-CAN (-) CIRCUITS FOR A SHORT TO GROUND WITH THE DSM DISCONNECTED

-

Disconnect: DSM C341b.

-

Measure the resistance between the DLC C251-3, circuit VDB06 (GY/OG), harness side and ground; and between the DLC C251-11, circuit
VDB07 (VT/OG), harness side and ground.

Initial Inspection and Diagnostic Overview|Page 3177 > < Initial Inspection and Diagnostic Overview|Page 3175