F 250 2WD Super Duty V10-6.8L (2009)
6. Fold the 60 percent portion of the rear 60/40 seat backrest forward.
All seats
7. Remove the center safety belt retractor cover bezel.
8. Pull to release the clips and remove the center safety belt retractor cover.
-
Feed the center safety belt retractor belt and tongue through the center safety belt retractor cover.
9. Remove the center safety belt retractor.
1. Remove the 2 center safety belt retractor D-ring nuts (1 shown).
-
To install, tighten to 30 Nm (22 lb-ft).
2. Separate the center safety belt retractor D-ring from the sheet metal.
3. Remove the center safety belt retractor bolt.
-
To install, tighten to 30 Nm (22 lb-ft).
4. Slide the center safety belt retractor up, releasing the tab and remove the center safety belt retractor.
10. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
11. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety
Belt System See: Testing and Inspection/Component Tests and General Diagnostics.
