F 250 2WD Super Duty V10-6.8L (2009)
11. Remove and discard the selector lever cable retaining clip.
-
Lift the lock tabs on the retaining clip arms to release the clip. Pull the clip and selector lever cable from the selector lever cable bracket.
12. Remove the cable.
13. Remove the bolts and selector lever cable bracket from the transmission.
Installation
1. Install the selector lever cable bracket onto the transmission.
-
Tighten to 48 Nm (35 lb-ft).
2. Move the manual control lever into the (D) position by moving it all the way forward, and then move it 3 detents rearward.
3. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever
cable into the bracket and listen for the cable to click in place. Pull back on the selector lever cable to make sure that it is locked into the bracket.
Install the selector lever cable into the bracket and install a new retaining clip.
