F 250 2WD Super Duty V10-6.8L VIN S (1999)
Front Door Latch: Service and Repair
Remote Control, Audio - Stereo
REMOVAL
1. Remove the rear door interior trim panel.
2. Remove the rear door remote control.
1
Disconnect the necessary rods and cables.
2
Remove the rivets.
1. Remove the rivet mandrill (center).
2. Drill out the rivet starting with a 15/64-inch drill bit. Do not exceed a 1/4-inch drill bit for final drilling.
3
Remove the rear door remote control.
CAUTION: When drilling out the latch remote control rivets, do not oversize the holes in the door sheet metal.
INSTALLATION
1. Follow the removal procedure in reverse order.
NOTE: If the component is to be replaced, refer to the Ford Master Parts Catalog for specific part information. The linkage must be adjusted
during installation. Refer to Specifications for the correct replacement of the latch remote control rivets.
