F 250 2WD Super Duty V10-6.8L VIN S (1999)
d.
Position a jack stand under the fuel tank and remove the fuel tank strap retaining bolts.
e.
Lower the fuel tank 6-8 inches to gain enough clearance, then install the stop plate assembly upper strap onto the crossmember. Do not
tighten the nut at this time. See Figure 4.
2.
Insert the spacers in the mounting bracket and install the mounting bracket on the inside of the frame rail where the holes were previously
enlarged. Make sure the bolts go through the bracket, then the frame, and the nuts are on the outside of the frame. Tighten the 12 mm bolts to 90
Nm (66 lb-ft) and the 10 mm bolt to 40 Nm (30 lb-ft). See Figure 5.
