F 250 2WD Super Duty V10-6.8L VIN S (1999)
Brake Pad: Service and Repair
Rear
Removal
1. Remove the brake master cylinder filler cap. Check brake fluid level in brake master cylinder reservoir. Remove fluid until brake master cylinder
reservoir is half full.
2. Raise and support the vehicle.
3. Remove the wheel and tire assembly.
4. Inspect the brake pads for wear or contamination. Replace if worn, damaged or past specification.
5. Remove the caliper pin bolts.
6. CAUTION: Never allow the rear disc brake caliper to hang from the brake hose. Provide suitable support.
Remove the rear disc brake caliper.
