F 250 2WD Super Duty V10-6.8L VIN S (1999)
7. Connect the rear parking brake cable at the parking brake cable equalizer.
8. Install the rear disc brake rotor.
-
Use the Brake Adjusting Gauge to set the rear brake shoe and lining diameter to 0.76 mm (0.030 inch) less than the inside diameter of the
drum portion of the rear disc brake rotor.
9. Install the tire and wheel assembly.
10. Lower the vehicle.
11. Burnish the parking brake shoe and linings.
1
Accelerate the vehicle to 24 km/h (15 mph).
2
Shift the transmission to NEUTRAL.
3
Slowly apply the parking brake control to approximately one-half to three-quarters of its travel.
4
Allow the vehicle to come to a complete stop.
5
Release the parking brake.
