F 250 2WD Super Duty V10-6.8L VIN S (1999)
Deactivator Switch: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally,
drink water and induce vomiting. Get medical attention immediately.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it
will water.
2. Disconnect the deactivator switch electrical connector.
3. Remove the deactivator switch.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE:
-
When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy.
The vehicle may need to be driven 16 km (10 mi) or more to relearn the strategy.
-
After the deactivator switch is installed, it is necessary to bleed the brake system.
