F 250 2WD Super Duty V10-6.8L VIN S (1999)
14. Remove the bolts.
15. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These
tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
Remove the engine front cover from the front cover to cylinder block dowel.
^
Remove the engine front cover gasket and clean and inspect the mating surfaces.
Installation
1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These
tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
NOTE: If the engine front cover is not secured within four minutes, the sealant must be removed and the sealing area cleaned with Metal Surface
Cleaner F4AZ-19A536-RA or equivalent meeting Ford specification WSE-M5B392-A. Allow to dry until there is no sign of wetness, or four
