F 250 2WD Super Duty V10-6.8L VIN S (1999)
Air Bag: Service and Repair
Removal and Installation
Driver's Side
Module - Driver Air Bag
Removal
WARNING: If replacing a deployed air bag module, always replace the air bag electronic crash sensor (ECS) module.
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
WARNING: Carry a live air bag module with the air bag and trim cover pointed away from your body. This will reduce the risk of injury in the event
of an accidental deployment.
WARNING: Do not set a live air bag module down with the trim cover face down.
WARNING: After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is
irritating to the skin. Wash your hands with soap and water afterwards.
WARNING: Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
WARNING: Air bag modules with discolored or damaged trim covers must be replaced, not repainted.
WARNING: Vehicle sensor orientation is critical for proper system operation. If a vehicle equipped with an air bag supplemental restraint system
(SRS) is involved in a collision, inspect the sensor mounting bracket and wiring pigtail for deformation. If damaged, replace the sensor whether or not
the air bag is deployed.
WARNING: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing or replacing
any air bag supplemental restraint system (SRS) components. To deplete the backup power supply energy, disconnect the battery ground cable and
wait one minute. Be sure to disconnect auxiliary batteries and power supplies (if so equipped).
NOTE: Repair is made by replacement only. If a part is replaced and the new part does not correct the condition, install the original part and perform
the diagnostic procedure again.
1. Disconnect the battery ground cable (14301).
2. Remove the driver air bag module.
1
Remove the two back cover plugs.
2
Remove the two driver air bag module screws.
3
Disconnect the horn electrical connector.
4
Disconnect the air bag sliding contact electrical connector.
5
Remove the driver air bag module.
Installation
1. WARNING: If replacing a deployed air bag module, always replace the air bag electronic crash sensor (ECS) module.
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
