F 250 2WD Super Duty V10-6.8L VIN S (1999)
2. Push in on the two glove compartment door tabs and position downward.
3. Disconnect the passenger air bag module.
1
Disconnect the harness connectors from the passenger air bag module bracket.
2
Disconnect the passenger air bag module electrical connector.
3
Remove the four passenger air bag module retaining screws.
4. Remove the passenger air bag module.
1
Using a 3/8-inch x 4-inch flat head screwdriver, or equivalent, carefully slide the head of the screwdriver under the right bottom edge of the
door and lift upward, separating the door from the clip. Separate the rest of the door from the clips by lifting the door with your hands.
2
Remove the passenger air bag module.
Installation
1. WARNING: If replacing a deployed air bag module, always replace the air bag electronic crash sensor (ECS) module.
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module.
WARNING: Carry a live air bag module with the air bag and deployment door pointed away from your body. This will reduce the risk of injury in the
event of an accidental deployment.
WARNING: Never probe the connectors on the air bag module. Doing so can result in air bag deployment which can result in personal injury.
NOTE: Repair is made by replacement only. If a part is replaced and the new part does not correct the condition, install the original part and perform
the diagnostic procedure again.
NOTE: Make sure to tighten the retaining bolts to specification.
