F 250 2WD Super Duty V8-5.4L (2008)
6.
Install the new seat back on the inboard pivot of the cushion pan, making sure the seat back is fully seated on the pivot pin. See Figure 5.
7.
Install 2 new recliner-to-seat back bolts and tighten to 50 Nm (37 lb-ft).
8.
Reinstall the lumbar support to the seat back, making sure the retainer clips are fully seated and that the lumbar cable is routed correctly in front of
the seat back. See Figure 6.
9.
Carefully install the supplied new silk film bag onto the seat back.
