F 250 2WD Super Duty V8-5.4L (2008)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the LH engine mount.
3. Remove the 3 bolts and position the power steering pump assembly aside.
^
To install, tighten to 25 Nm (18 lb-ft).
4. Disconnect the lower radiator hose from the oil filter adapter and position it aside.
5. Disconnect the degas bottle hose from the oil filter adapter and position it aside.
6. Disconnect the engine oil pressure (EOP) switch electrical connector.
7. Remove the EOP switch.
^
To install, tighten to 18 Nm (13 lb-ft).
8. Remove the oil filter adapter nut.
^
To install, tighten to 48 Nm (35 lb-ft).
9. Remove the 4 bolts and the oil filter adapter.
^
To install, tighten to 25 Nm (18 lb-ft).
