F 250 2WD Super Duty V8-5.4L (2008)
3. Remove the engine cooling fan shroud. For additional information, refer to Cooling System.
4. Remove the engine cooling fan. For additional information, refer to Cooling System.
5. Remove the RH valve cover.
6. Remove the LH valve cover.
7. Loosen the 4 coolant pump pulley bolts.
8. Rotate the tensioner clockwise and remove the accessory drive belt.
9. Remove the bolt and the accessory drive idler pulley.
10. Remove the 3 bolts and the accessory drive belt tensioner.
11. Remove the crankshaft pulley bolt and washer.
^
Discard the crankshaft pulley bolt.
12. Using the special tool, remove the crankshaft pulley.
13. Using the special tool, remove and discard the crankshaft front seal.
14. Remove the 3 bolts and position the power steering pump assembly aside.
15. Remove the 2 nuts and the RH and LH radio ignition interference capacitors.
16. Disconnect the RH camshaft position (CMP) sensor electrical connector.
17. Remove the bolt and the RH CMP sensor.
18. Disconnect the LH CMP sensor electrical connector.
19. Remove the bolt and the LH CMP sensor.
