F 250 2WD Super Duty V8-5.4L (2008)
20. Remove the 4 bolts and the coolant pump pulley.
21. Disconnect the crankshaft position (CKP) sensor electrical connector.
22. Remove the nut and the starter wiring harness and transmission cooler tube support brackets from the stud bolt.
23. Remove the 4 front oil pan bolts.
24. Remove the bolts and the studs.
25. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These
tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant. Failure to follow
this procedure may cause future oil leakage.
Remove the engine front cover from the front cover to cylinder block dowel.
^
Remove the engine front cover gaskets.
^
Clean the mating surfaces with Silicone Gasket Remover and Motorcraft Metal Surface Prep. Follow the directions on the packaging.
^
Inspect the mating surfaces.
26. Remove the bolt and the CKP sensor.
Installation
1. NOTE: Lubricate the O-ring seal with clean engine oil prior to installation.
Install the CKP sensor and the bolt.
^
Tighten to 10 Nm (89 lb-inch).
2. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These
tools cause scratches and gouges which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
NOTE: If the engine front cover is not secured within 4 minutes, the sealant must be removed and the sealing area cleaned. To clean the sealing
area, use Silicone Gasket Remover and Motorcraft Metal Surface Prep. Follow the directions on the packaging. Allow to dry until there is no sign
of wetness, or 4 minutes, whichever is longer. Failure to follow this procedure may cause future oil leakage.
NOTE: Make sure that the engine front cover gasket is in place on the engine front cover before installation.
Apply a bead of Silicone Gasket and Sealant along the cylinder head-to-cylinder block surface and the oil pan-to-cylinder block surface, at the
locations shown.
