F 250 2WD Super Duty V8-5.4L (2008)
contamination from a failed A/C compressor or damage to the suction accumulator.
1. Recover the refrigerant.
2. Remove the condenser inlet and outlet fitting nuts and disconnect the fittings.
-
Discard the O-ring seals and gasket seals.
-
To install, tighten to 15 Nm (11 lb-ft).
3. Detach the hood release cable pin-type retainer from the power steering cooler.
4. Remove the 2 power steering cooler bolts.
-
To install, tighten to 11 Nm (8 lb-ft).
5. Position the power steering cooler aside.
6. Remove the horn assembly bracket bolt and position the horn assembly aside.
-
To install, tighten to 11 Nm (8 lb-ft).
7. Remove the 2 condenser bolts.
-
To install, tighten to 11 Nm (8 lb-ft).
8. Remove the condenser core.
9. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
10. Evacuate, leak test and charge the refrigerant system.