F 250 2WD Super Duty V8-5.4L (2008)
Failure to follow this instruction may result in the air bag deploying incorrectly, which increases the risk of serious personal injury or death in a
crash.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
1. Depower the SRS.
2. Open and lower the glove compartment door.
3. NOTE: During installation, 4 new air bag module deployment door screws must be installed.
Remove and discard the 4 passenger air bag module deployment door screws.
4. CAUTION: Do not handle the passenger air bag module by grabbing the edges of the deployment door. Failure to follow this instruction
may result in component damage and/or system failure.
NOTE:
-
During installation, 4 new air bag module bolts must be installed.
-
Check the positioning of the passenger air bag module J-nuts before positioning the passenger air bag module to the I/P.
Remove and discard the 4 bolts and position out the passenger air bag module from the instrument panel (I/P)
-
To install, tighten to 9 Nm (80 lb-in).
5. Disconnect the electrical connector and remove the passenger air bag module.
6. To install, reverse the removal procedure.
7. Repower the SRS.
