F 250 2WD Super Duty V8-5.4L (2008)
Alignment: Service and Repair
Camber and Caster Adjustment
Camber and Caster Adjustment - F-250 and F-350 Rear Wheel Drive (RWD)
1. Using alignment equipment and the manufacturer's instructions, measure the caster and camber.
^
Refer to Alignment Specifications for optimal alignment settings.
^
If the caster and camber values are not within specification, go to the next step.
2. Remove the upper ball joint pinch bolt and nut.
^
Discard the nut.
3. Remove the existing adjuster sleeves. All vehicles are built by the assembly plant with a non-adjustable camber/caster sleeve.
1. Service adjusters have a 6-sided flange with the camber/caster adjustment range stamped into the top (0 degree, 1/4 degree, 1/2 degree, 3/4
degree or 1 degree, 1-1/4 degree and 1-1/2 degree).
2. Production adjusters have a round flange with a side tab. The amounts of pre-set camber and caster are stamped into the top of the adjuster.
4. Install interim 0 degree service adjusters to both sides of the vehicle.
5. Install the upper ball joint pinch bolt and a new nut.
^
Tighten to 80 Nm (59 ft. lbs.).
6. Install the front wheel(s) and check caster and camber readings with the 0 degree service adjusters installed.
7. Calculate the maximum amount of camber and/or caster adjustment required to achieve the optimal settings, as provided in the Alignment
