F 250 2WD Super Duty V8-5.4L (2008)
3. Disconnect and position aside the ABS module electrical connector.
4. Disconnect the steering gear shield from the line fitting and position the shield up on the lower steering column shaft.
F-250/350 vehicles
5. Disconnect the return hose-to-steering gear fitting.
^
Discard the O-ring seal.
^
To install, tighten to 35 Nm (26 ft. lbs.).
6. Unclip the return hose from the retainer clip.
All vehicles
7. Disconnect the pressure line-to-steering gear fitting.
^
To install, tighten to 35 Nm (26 ft. lbs.).
8. Disconnect the pressure line-to-jumper line fitting.
^
To install, tighten to 35 Nm (26 ft. lbs.).
9. Unclip the hydraulic booster-to-steering gear pressure line from the 2 pressure line retainers and remove the pressure line.
10. To install, reverse the removal procedure.
^
Install a new O-ring seal on the return hose-to-steering gear fitting.
^
Fill the power steering system.