2008 F-250 2WD Super Duty V8-54L Power Steering Pump Repair | Page 8123
Removal and Installation
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power
steering components may result.
NOTE: New Teflon(R) seals must be installed any time the power steering line fittings are disconnected.
1. Remove the power steering pump pulley.
2. Release the clamp and disconnect the power steering pump supply hose.
3. Remove the pressure line bracket/pump bolt.
^
To install, tighten to 25 Nm (18 ft. lbs.).
4. Disconnect the pressure line-to-pump fitting.
^
Discard the Teflon(R) seal.
