F 250 2WD Super Duty V8-5.4L (2008)
4. Disconnect the driveshaft from the coupling shaft.
1. Remove and discard the 4 bolts.
2. Remove the 2 U-joint retainers.
-
Using mechanic's wire, support the driveshaft.
5. Index-mark the center support bearing bracket for reference during installation.
6. Remove the 2 center bearing support bolts.
7. Remove the rear coupling shaft assembly.
8. NOTE: It may be necessary to tap the driveshaft yoke with a plastic or rubber soft-faced hammer if a pry area is not available on the driveshaft
yoke.
Remove and discard the 4 flange bolts.
9. Index-mark the center support bearing bracket for reference during installation.
10. Remove the 2 center bearing support bolts.
11. Remove the front driveshaft.
