F 250 2WD Super Duty V8-5.4L (2008)
-
Tighten to 62 Nm (46 lb-ft).
7. NOTE: The flange fits tightly on the rear axle pinion flange pilot. To make sure that the yoke seats squarely on the flange, tighten the bolts evenly
in a cross pattern as shown.
Connect the rear coupling shaft assembly to the rear axle. Install the 4 new bolts.
-
Tighten in the sequence shown, to 100 Nm (74 lb-ft).
8. NOTICE: Make sure that the center bearing is correctly aligned when tightening fasteners or bearing failure and/or NVH issues may
occur.
Tighten the 2 center bearing support bolts.
-
Tighten to 70 Nm (52 lb-ft).
