F 250 2WD Super Duty V8-5.4L VIN 5 (2006)
Sunroof / Moonroof Frame: Service and Repair
ROOF OPENING PANEL FRAME
Removal and Installation
NOTE: The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof
opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed or when a new roof
opening panel assembly has been installed.
1. Remove the headliner.
2. Remove the overhead console bracket.
1
Remove the screws.
2
Remove the bracket.
3. Disconnect the electrical connector.
4. Remove the roof opening panel frame.
1
Disconnect the 4 roof opening panel drain hoses.
2
Remove the 11 bolts.
-
To install, tighten to 10 Nm (89 lb-in).
3
Remove the roof opening panel frame.
5. To install, reverse the removal procedure. If a new roof opening panel frame is being installed, transfer the existing roof opening panel motor, air
deflector, rear trough, roof opening panel glass and roof opening panel shield onto the new frame assembly. Initialize the roof opening panel
motor.
