F 250 2WD Super Duty V8-5.4L VIN 5 (2006)
Fluid - A/T: Service and Repair
Transmission Fluid Drain and Refill - Automated Equipment
Transmission Fluid Drain and Refill Automated Equipment
Special Tool(s)
Material
Draining
CAUTION: Always refer to the instructions supplied with the flush and fill machine.
1. With the vehicle in PARK, position it on a hoist.
2. Use a suitable flush and fill machine to change the fluid.
3. When connecting the flush and fill machine, connect the machine to the fluid cooler tube after the fluid cooler on the cooler return tube. This will
help remove any foreign material trapped in the fluid coolers.
Refill
1. Once the fluid exchange has been completed, disconnect the flush and fill machine. Reconnect any disconnected fluid cooler tubes.
2. With the engine running and the transmission at normal operating temperature 66 - 77°C (150 - 170°F), check and adjust the transmission fluid
level, and check for any leaks. If fluid is needed, add fluid in increments of 0.24 liter (0.5 pint) until the correct level is achieved (fluid should be
in the cross-hatched area of the fluid level indicator).
