F 250 2WD Super Duty V8-5.4L VIN 5 (2006)
Removal and Installation
CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power
steering components can result.
NOTE: New Teflon(R) seals must be installed any time the power steering line fittings are disconnected.
1. Using a suitable suction device, drain the power steering fluid reservoir.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Remove the lower power steering pump bolt.
^
To install, tighten to 25 Nm (18 ft. lbs.).
4. NOTE: Thoroughly clean all foreign material from the threads.
NOTE: To prevent fluid leakage, be sure to insert the pressure line into the quick connect before positioning the pressure line bracket and
tightening the lower power steering pump bolt.
Disconnect the pressure line-to-pump fitting.
^
Discard the Teflon(R) seal.
^
To install, tighten to 35 Nm (26 ft. lbs.).
5. NOTE: Thoroughly clean all foreign material from the threads of the fitting.
Disconnect the pressure line-to-steering gear fitting and remove the pressure line.
^
Discard the Teflon(R) seal.
^
To install, tighten to 35 Nm (26 ft. lbs.).
6. To install, reverse the removal procedure.
^
Using the special tool, install 2 new Teflon(R) seals on the pressure line fittings.
^
Fill the power steering system.
