Fuel Level Sensor Replacement for F-250 2WD Super Duty V8-54L VIN 5 (2006)
Fuel Level Sensor: Service and Repair
Fuel Pump Module - Steel Fuel Tank
FUEL PUMP MODULE - STEEL FUEL TANK
Removal and Installation
WARNING:
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable
mixtures are always present and may be ignited. Failure to follow these instructions can result in personal injury.
-
Fuel in the fuel system remains under high pressure even when the engine is not running. Before repairing or disconnecting any of the
fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing personal injury or a fire
hazard.
NOTE: This procedure is for gasoline applications only.
1. NOTE: The fuel tank must be drained completely. Upon removal of the fuel pump module, the tank must be inspected for contamination.
Remove the fuel tank.
2. Clean the area around the fuel pump mounting flange.
3. Remove the 6 bolts from the fuel pump module.
-
To install, tighten to 10 Nm (89 lb-in).
4. CAUTION: The fuel pump module must be handled carefully to avoid damage to the float arm.
Completely remove the fuel pump module from the fuel tank.
5. CAUTION:
