F 250 2WD Super Duty V8-5.4L VIN 5 (2006)
2. Connect the RCM.
1
Install the bolt.
-
Tighten to 12 Nm (9 lb-ft).
2
Connect the RCM electrical connector.
3
Engage the RCM electrical connector locking clip.
3. Install the RCM cover.
4. Repower the system. Do not prove out the system at this time.
5. NOTE: When a new RCM is first installed in the vehicle, module configuration must be carried out. If the RCM is incorrectly configured,
erroneous DTC(s) will result.
If a new RCM is being installed, configure the RCM using a diagnostic tool.
6. Prove out the supplemental restraint system (SRS) as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag indicator with the air bag
modules installed. The air bag indicator will light continuously for approximately 6 seconds and then turn off. If an air bag supplemental restraint
system (SRS) fault is present, the air bag indicator will:
-
fail to light.
-
remain lit continuously.
-
flash.
The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is the
time required for the restraints control module (RCM) to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS fault
exists, a chime will sound in a pattern of 5 sets of 5 beeps. If this occurs, the air bag indicator and any SRS fault discovered must be diagnosed and
repaired.
Clear all continuous DTCs from the restraints control module using a diagnostic tool.
