F 250 2WD Super Duty V8-5.4L VIN 5 (2006)
Child Seat Tether Attachment: Service and Repair
CHILD SAFETY SEAT TETHER ANCHOR
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensor (BTS), if equipped, buckles, shoulder belt height adjusters [if
equipped], child safety seat tether attachments and attaching hardware) should be inspected after every collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted. Failure to follow these
instructions could increase the risk of injury in collisions.
SuperCab vehicles
1. From the bottom of the seat backrest, push the seat backrest upward, then pull the bottom outward and remove from the vehicle.
Regular cab vehicles
2. Position the front seat(s) FORWARD.
Crew Cab vehicles
3. Position the rear seat backrest DOWN.
Regular and Crew Cab vehicles
4. NOTE: RH side shown, all others similar.
Remove the bolt and the child safety seat tether anchor.
-
To install, tighten to 30 Nm (22 lb-ft).
SuperCab vehicles
