F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
4. Remove the two nuts.
5. Carefully pry the body side-to-roof moulding away from the vehicle body.
INSTALLATION
1. Clean out all remaining sealant from the body side to roof joint and replace with Ford Caulking Cord D6AZ-19560-A or equivalent meeting Ford
specification ESB-M4G32-A.
2. Position a new body side-to-roof moulding (painted to match) on the vehicle and press into place.
3. Install the nuts.
4. Install the rear cab corner trim panel, safety belt and rear seat (if applicable).
Trim Panel - Tailgate, Upper
TRIM PANEL - TAILGATE, UPPER
REMOVAL
1. Remove the screws and remove the tailgate access panel.
2. NOTE: Use extreme care while removing the tailgate trim panel. The component is easily damaged during removal.
Remove the tailgate trim panel.
1
Remove the scrivets.
2
Pull the tailgate trim panel away from the tailgate.
INSTALLATION
