F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
22. Install one lifting eye on the LH cylinder head.
23. CAUTION: Do not use the special tool to raise the engine. Damage to the special tool or vehicle may occur.
NOTE: The ball studs may have to be removed.
NOTE: This procedure requires a second bolt hook assembly. The tools are available through Rotunda Tools with the following numbers: bolt
hook 303-FO70-6, handle 303-FO70-8, bracket 303-FO70-7 and washer 303-FO70-12004.
Install the special tool.
24. NOTE: The engine must be raised evenly.
Using a lifting crane, raise the engine until the turbocharger is about to touch the cowl. Secure the engine with the special tool.
25. Remove the RH fender splash shield.
26. NOTE: Rear is shown; front is similar.
Remove the four motor mount bolts.
