F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
Heater Hose: Service and Repair
Removal and Installation
AUXILIARY HEATER OUTLET AND INLET LINE
REMOVAL
CAUTION: It may be necessary to cut the underbody auxiliary line(s) being serviced into sections to facilitate removal. Make sure to correctly
identify the line(s) being serviced before carrying out any cutting of the line(s).
NOTE: Lay out the new lines in vehicle position to assist in the installation.
1. Position the vehicle on a hoist with the gear selector in NEUTRAL.
2. Drain the cooling system.
3. Remove the RH fender splash shield.
4. Remove the RH rear wheel.
5. NOTE: If only one auxiliary heater line is to be removed, disconnect only the desired line.
At the rear of the vehicle, release the clamps and disconnect the auxiliary heater line(s).
6. Remove the five line bracket retaining nuts.
7. CAUTION: Pull the bracket off the stud before attempting to pry off the lines to prevent component damage.
Remove the five line brackets by inserting a screwdriver in the stud hole and twisting.
