F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
2. NOTE: Do not discard the fluid pan gasket unless damaged. This is a reusable gasket.
Remove the transmission fluid pan and gasket.
1
Loosen, but do not remove the bolts.
2
Remove the front and side bolts.
3
Lower the front of the fluid pan and allow the fluid to drain.
4
Remove the remaining fluid pan bolts and the fluid pan.
3. Do not remove or install a new fluid filter.
4. NOTE: If equipped with a radiator in-tank transmission fluid cooler, the cooler will need to be flushed.
Only flush the cooler tubes, in-tank fluid coolers and the bypass valve if carrying out a transmission overhaul. Vehicles equipped with auxiliary
OTA coolers cannot be flushed completely. Only new coolers should be installed.
Refill
5. NOTE: Do not discard the gasket unless damaged. This is a reusable gasket.
NOTE: Apply a light coat of petroleum jelly to hold the gasket to the fluid pan.
Position the gasket onto the clean fluid pan. Make sure the magnet is positioned over the dimple in the fluid pan.
6. Install the pan with the gasket. Alternately tighten the bolts.
7. CAUTION: The use of any other transmission fluid than specified can result in the transmission failing to operate in a normal manner or
transmission failure.
Fill the transmission.
^
Add 6.2 liters (6.5 qts) of clean automatic transmission fluid to the transmission through the fluid filler tube.
