F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
Only flush the cooler tubes, in-tank fluid coolers and the bypass valve if carrying out a transmission overhaul. Vehicles equipped with auxiliary
OTA coolers cannot be flushed completely. Only new coolers should be installed.
Refill
8. After the torque converter has drained, install a new drain plug.
9. Install the torque converter drain plug cover.
All vehicles
10. Install the pan with the gasket. Alternately tighten the bolts.
11. CAUTION: The use of any other transmission fluid than specified can result in the transmission failing to operate in a normal manner or
transmission failure.
Fill the transmission.
^
Add 6.2 liters (6.5 qts) of clean automatic transmission fluid to the transmission through the fluid filler tube.
12. Start the engine. Move the transmission range selector lever through all the gear ranges, checking for engagements.
13. With the engine running and the transmission at normal operating temperature 66 - 77°C (150 - 170°F), check and adjust the transmission fluid
level, and check for any leaks. If fluid is needed, add fluid in increments of 0.24 liter (0.5 pint) until the correct level is achieved (fluid should be
in the cross-hatched area of the fluid level indicator).
