F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
INSPECTION
1.
If necessary, disconnect the hot-side charge air cooler (CAC) duct (passenger side of the vehicle) from the turbocharger outlet duct cuff.
2.
Inspect the FICM harness for a part number tag. If present, it will be located between two (2) of the fuel injector harness takeouts. See Figure 1.
[NEW]NOTE: The part number on the tag shows the International(R) part number for the FICM harness.
It differs from Ford Motor Company part numbers. The International(R) part number is a string of numbers that should end in C97. C97
will be larger than the other numbers on the harness tag.
^
If no tag is present, continue with this inspection.
^
If the tag is present but the part number ends in anything but C97, continue with this inspection.
^
If the tag is present and the part number ends in C97, the only FICM harness service required is replacement of the ICP sensor
connector. Proceed to Sensor Connector Replacement in this Attachment V.
3.
Remove the air filter cartridge, the outlet tube and the clean air tube. See Figure 2.
