F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
8. Remove the fuel rail plug. Clean the fuel gallery with a wire brush. Use filtered compressed air to remove the debris from the gallery. Install the
fuel rail plug.
INSTALLATION
1. Verify the fuel injector bore is clean and dry.
2. Position the fuel injector sleeve onto the Injector Sleeve Replacer. Apply Threadlock 262(R) or equivalent to the very bottom (smallest diameter)
and very top (largest diameter) flat areas.
3. Position the fuel injector sleeve into the cylinder head fuel injector bore. Seat the fuel injector sleeve in the fuel injector bore, using a rubber
mallet. If any sealant gets into the inside of the injector sleeve, it must be cleaned out before it hardens.
4. Install the press-in-place gasket.
-
Install the dowels and the gasket.
