F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
7. NOTE: Use a 1-1/16 inch 12 pt. deep flare nut crowfoot wrench, such as a Snap-On(R) AN850817B, GAN850817B or equivalent, to remove the
sensor.
Remove the ICP sensor.
INSTALLATION
All vehicles
1. NOTE: Verify the ICP sensor has the O-ring place.
Install the ICP sensor.
2. Connect the ICP electrical connector.
-
Position the heat wrap back over the electrical connector.