F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
NOTE:
Based on when the vehicle being serviced was built, it may have some of the protection kit components, such as harness connector covers, already
installed from the factory. Also, the kit includes additional parts such as rubber caps used to protect the harness from contact with studs and extra
convolute that does not require installation. The kit was designed by International(R) for other service issues.
Install only the kit components necessary to fulfill the requirements of this recall.
1.
Install the harness connector covers onto both FICM injector harness connectors by carefully bending the wires coming out of the connector and
snapping the cover in place. See Figure 5.
2.
Position and install the plastic TEE over the forward harness take-out with the narrowed end toward the rear of the vehicle. Do not latch the TEE
closed at this time. See Figure 6.
3.
Cut two (2) pieces of 11/16" convolute: one (1) approximately 75 mm (3 inches) long, the other about 37 mm (1.5 inches) long. See Figure 6.
4.
Position the 75 mm (3 inches) section of convolute over the harness takeout from the plastic TEE to the FICM connector. See Figure 6.
