F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
2.
Loosen the clamps at both ends of the blow-molded CAC duct. Remove the duct and clamps then discard. See Figure 1.
3.
Using Motorcraft Metal Brake Parts Cleaner PM-4, thoroughly clean the CAC outlet port and intake manifold inlet port of any oil residue or dirt
that would interfere with an air-tight seal.
4.
CAUTION: When installing and tightening the clamps near the intake manifold on the new CAC duct, be sure to position them so they do not
come in contact with the hood.
Install the new CAC duct and rubber cuffs. Tighten the clamps to 12 Nm (9 lb-ft). See Figure 2.
5.
Reinstall the air filter inlet and outlet tubes and the air filter cartridge.
[NEW] ROAD TEST PROCEDURE
Refer to the Road Test Procedure in Emission Recall 05E15. This road test is to be performed only once per vehicle and only after all applicable recall
and service programs have been completed.
